|
|
Post by Marco C. on Apr 18, 2020 15:37:58 GMT
Hi, i use vJoy with UCR for the merge of 2 axis in 1, when i first run UCR vJoy work just fine but after some time if i move the axis no output is received by vJoy, to make it work again i have to open Configure vJoy and uncheck and check again "Enable vJoy".
|
|
njz3
New Member
Posts: 22
|
Post by njz3 on Jul 16, 2020 18:06:38 GMT
Hi,
When you see your bug: please check by shutting done UCR, then use the vJoy demo feeder and vJoy monitor to see if your axis is 'stuck' or not in vJoy.
Perform this without disabling/enabling vJoy.
If you see that the axis can move using vJoy's demo feeder, then the bug is probably in UCR.
|
|
